Hello
Have we got any MIT App Inventor users here? I put a simple Android app together to display information from a Google fusion table. The basics were straightforward but I would like to set up Screen 1 to display two of the three fusion table columns only. I'm guessing a select query is the way forward but I don't have the experience to set it up and after much searching I have failed to find any guidance.
Anyone know where I might find some fusion table guidance specific to my dilemma?
Regards
Graeme
App Inventor 2
-
- Cosmic Lounger
- Posts: 1189
- Joined: 11 Feb 2010, 12:23
- Location: Medway, Kent, UK
-
- Administrator
- Posts: 78233
- Joined: 16 Jan 2010, 00:14
- Status: Microsoft MVP
- Location: Wageningen, The Netherlands
Re: App Inventor 2
I don't know of any member of Eileen's Lounge who does, so if you don't get a reply within the next few days, you might ask at MIT App Inventor Support Forum.
Best wishes,
Hans
Hans
-
- Cosmic Lounger
- Posts: 1189
- Joined: 11 Feb 2010, 12:23
- Location: Medway, Kent, UK
Re: App Inventor 2
Hello Hans
Oh well, it was a bit of a hopeful question! I just didn't want to join any other forum!
I have looked at the MIT Support forum but didn't find anything specific to my question. I'll have to register with them and ask.
Thanks anyway.
Regards
Graeme
Oh well, it was a bit of a hopeful question! I just didn't want to join any other forum!
I have looked at the MIT Support forum but didn't find anything specific to my question. I'll have to register with them and ask.
Thanks anyway.
Regards
Graeme